Hi, SSH into a RT-AC1300UHP and see only eth0, eth1, ath0, ath1. (no eth2, eth3, etc like higher end RT-AC86U).
Does this mean that eth1 = "four-switchports-are-a-hardwired-bridge" and the 4 ports cannot be individually controlled? E.g, for separate VLAN trunking, bridges.
If this is the case how does IPTV settings put the respective port into the correct VLAN? Some firmware magic perhaps?
Update: this is a low-end device so that it uses the swconfig method with hardcoded mappings of...
RT-AC1300UHP - four switch ports (= eth1?) not individually addressable?
Does this mean that eth1 = "four-switchports-are-a-hardwired-bridge" and the 4 ports cannot be individually controlled? E.g, for separate VLAN trunking, bridges.
If this is the case how does IPTV settings put the respective port into the correct VLAN? Some firmware magic perhaps?
Update: this is a low-end device so that it uses the swconfig method with hardcoded mappings of...
RT-AC1300UHP - four switch ports (= eth1?) not individually addressable?